©Westermo Teleindustri ABUser Guide6651-22621www.westermo.comIndustrial Converter Serial RS-232 to fibre optic link Point-to-point applicationsODW-6
106651-22621Designed for harsh environments, such as industrial, road and railway applicationsThe ODW-620-F1 complies with standards for industrial e
116651-22621Status Port type Signal relay, changeover contactsRated voltage Up to 48 VDCOperating voltage Up to 60 VDCContact rating 500 mA @ 48 VDCCo
126651-22621FX (Fibre) SM-LC80 SM-LC40 SM-LC15 MM-LC2Fibre connector LC duplex LC duplex LC duplex LC duplexFibre type Singlemode 9/125 mmSinglemode 9
136651-22621Location of Interface ports, LED’s and DIP-switchesPosition Direction* DescriptionD-sub1 Out Data Carrier Detect (DCD)2 Out Received Data
146651-22621LED indicators LED Status DescriptionPWR PowerON In service (power)Flashing Fault conditionOFF Out of serviceRDR OFF Not usedCH 2 OFF Not
156651-22621ConfigurationAll needed configurations and parameter settings are done by the DIP-switches, located under the top lid.!DIP-switch settings
166651-22621CoolingThis unit uses convection cooling. To avoid obstructing the air-flow around the unit, use the following spacing rules. Minimum spac
176651-22621Configure the ODW-620-F1s. Using the factory DIP-switch settings, set: …S1: CTS always active or RTS/CTS control. …Connect The fibre link
186651-22621
196651-22621
26651-22621Legal informationThe contents of this document are provided “as is”. Except as required by applicable law, no warranties of any kind, eithe
REV.A 6651-22621 2012-12 Westermo Teleindustri AB, Sweden – A Beijer Electronics Group CompanyWestermo • SE-640 40 Stora Sundby, SwedenTel +46 16
36651-22621SafetyBefore installation:Read this manual completely and gather all information on the unit. Make sure that you understand it fully. Check
46651-22621Note. Fibre Optic HandlingFibre optic equipment requires careful handling as the fibre components are very sensitive to dust and dirt. I
56651-22621Declaration of Conformity Westermo Teleindustri AB Declaration of conformity Org.nr/ Postadress/Postal address Tel. Telefax Pos
66651-22621Type tests and environmental conditionsElectromagnetic CompatibilityPhenomena Test Description LevelESD EN 61000-4-2 Enclosure contact ± 6
76651-22621 STATUS C NO NC LED’s Switches CH 1 SFP Fibre transceiver TX RX Internal Electronics RS -232 SHIELD DCD RD TD SG DSR RTS CTS ODW-62
86651-22621Point-to-point communication via fibre optical network The serial data is transferred via a fibre optic network between two ODW-620-F1. Th
96651-22621Optical fibre link functionality and status indicationAt power on, all LED’s will be active during an initiation sequence followed by an au
Comments to this Manuals