Westermo Lynx-x08-F2G-S2 User Manual

©Westermo Teleindustri ABwww.westermo.comUser Guide6643-2220Industrial Ethernet 8-port Device Server SwitchLynx DSS L108 / L208-F2G-S2WeOS

106643-2220Location of interface ports and LED’sLED Indicators (for details see page 14)Power connection (for details see page 7 and 13)SFP transceive

116643-2220RS-232Position Signal Direction DescriptionNo. 1 DSR Out Data Set ReadyNo. 2 DCD Out Data Carrier DetectNo. 3 DTR In Data Terminal ReadyNo.

126643-2220Connection to console portThe console port can be used to connect to the CLI (Command Line Interface).The following steps needs to be take

136643-2220Power connectionI/O connection12344-position Product marking Direction DescriptionNo. 1 +DC1 Input Supply voltage input DC1No. 2 +DC2 Input

146643-2220LED indicatorsLED Status DescriptionON OFF Unit has no power.GREEN All OK, no alarm condition.RED Alarm condition, or until unit has starte

156643-2220MountingThis unit should be mounted on 35 mm DIN-rail, which is horizontally mounted inside an apparatus cabinet or similar. It is recommen

166643-2220Getting StartedThis product runs Westermo Operating System (WeOS) which provides several management tools that can be used for configurati

176643-2220Factory default on Lynx DSSIt is possible to set the unit to factory default settings by using two straight standard Ethernet RJ-45 cables.

26643-2220SafetyWarningDo not open connected unit. Hazardous voltage may occur within this unit when connected to power supply. Note that this unit ca

REV.G 6643-2220 2015-01 Westermo Teleindustri AB, Sweden – A Beijer Electronics Group CompanyFor complete contact information, please visit our w

36643-2220MaintenanceNo maintenance is required, as long as the unit is used as intended within the specified conditions.Agency approvals and standard

46643-2220Declaration of Conformity Westermo Teleindustri AB Declaration of conformity Org.nr/ Postadress/Postal address Tel. Telefax Post

56643-2220Product descriptionStatus ActivePorts 6 x RJ-45, 10/100BaseT. 4 x SFP, 100/1000 Mbit/s. 2 x RJ-45, RS-232/422/485.Description Managed Device

66643-2220EN 61000-4-9, pulsed magnetic field300 A/mEN 61000-4-3, radiated RF immunity20 V/m @ (80 – 2700) MHz 1 kHz sine, 80% AMEN 61000-4-6, cond

76643-2220MechanicalIEC 60068-2-6, vibrationIEC 60068-2-6,(sine), operating3 – 13.2 Hz: 1mm13.2 – 100 Hz: 0.7 g5.5 – 30 Hz: 1.5 g30 – 50 Hz: 0.42 mm5

86643-2220Interface specifications, 100/1000SFPOptical/Electrical specification IEEE std 802.3. 2005 EditionData rate 100 Mbit/s or 1000 Mbit/s transc

96643-2220Interface specifications, I/O relay outputMaximum voltage / current 60 VDC / 80 mAConnect resistance Max 30 ΩIsolation to All otherConnectio