Westermo GS-01 User Manual download pdf (Page 29)

296195-2201

+ICF – DTE-DCE character framing

This command is used to determine the local serial port start-stop (asynchronous)

character framing that the DCE shall use.

Command syntax: AT+ICF= <format>, <parity>

* <format>:

0 Autodetect Not supported

1 8 Data 2 Stop supported

2 8 Data 1 Parity 1 Stop supported

3 8 Data 1 Stop supported

4 7 Data 2 Stop supported

5 7 Data 1 Parity 1 Stop supported

6 7 Data 1 Stop supported

* <parity>:

0 Odd Supported

1 Even Supported

2 Mark Supported

3 Space Supported

4 None Supported

Note 1) Setting a character framing different from 8N1 will disable autobauding

(in the case it was activated). However setting it back to 8N1 will not re-enable

autobaud.

Note 2) Setting the framing to 8N1 will let the autobauding enabled, if it was already

enabled (implying framing was already 8N1).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

No comments

Westermo GS-01 User Manual Page 29