Westermo FD-40 User Manual download pdf (Page 14)

14 6630-2242

6.4.2 On-line configuration by FD-Tool

This part will only describe the usage of FD-Tool to perform an on-line configuration.For

FD-Tool installation and general FD-Tool handling,see “FD-Tool installation manual” on

the CD, FD-Tool.

The FD-40 goes into configuration mode, a connection with FD-Tool, immediately after a

power on.The serial interface is set as follows, and should not be changed.

RS-232 9 600 bit/s no parity 8 data bits 1 stop bit data control

Initiate an on-line configuration

• Start the FD-Tool.

• Connect a DTE-DTE serial cable (zero-modem) to the serial port of the PC and the

RS-232 port of the FD-40.

• Initiate communication between the FD-Tool and the FD-10 by selecting Connect >

RS-232.The FD-Tool will attempt to get communication until a successful connection

or a manual cancel.

• Power the connected FD-40.The CONF LED of FD-40 will be active and remain so as

long as the FD-40 is in configuration mode. After some seconds,the connection will

established and the Status (to left in lower border of FD-Tool window) will be changed

from Disconnected to Connected.If the CONF LED will be inactive (after about

3 seconds),the initiation of on-line configuration is failed. If failed,check the serial

cable and that all S1 switches are set to off.Power on the device again.

• The FD-Tool shows the device type of this FD-40,present configuration,or the default

configuration whether the FD-40 is used for the first time.

Modify configuration

Configurations are defined per device type, see “Functional description”, chapter 7.

FD-40 B Buffered

Load configuration to FD-40

• The present configuration,shown by FD-Tool, will be loaded to the FD-40 by selecting

File > Configuration > Load to device.

• This loaded configuration will be running in normal operation after a new power on

and when the CONF LED has been set to inactive.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

Westermo FD-40 User Manual Page 14