Industrial EthernetSHDSL Extenderwww.westermo.com©Westermo Teleindustri ABUser Guide6621-2202DDW-100
106621-2202Interface specificationsPowerRated voltage 12 to 48 VDCOperating voltage 10 to 60 VDCRated current 290 mA @ 12 VDC 140 mA @ 24 VDC 80 mA
116621-2202* To minimise the risk of interference, a shielded cable is recommended when the cable is located inside 3 m boundary to the rails and con
Position Direction DescriptionNo. 1 NCNo. 2 NCNo. 3 In/Out 2-wire Receive/ Transmit SHDSLNo. 4 In/Out 2-wire Receive/ Transmit SHDSLNo. 5
LED Status Indication ofPWR OFF Unit has no power ON Internal power Slow flash Initialisation progressing Fast FLASH Initialisation error
146621-2202S1* DIP-switchDIP-switch settingsBefore DIP-switch settings:Prevent damage to internal electronics from electrostatic discharges (ESD) by d
156621-2202S2 DIP-switchAnnex B enabled, manual peed selectedFactory settingsS2ON 1 2 3 4Annex B EnabledON 1 2 3 4Reserved for Annex AON 1 2
166621-2202CoolingThis unit uses convection cooling. To avoid obstructing the air-flow around the unit, use the following spacing rules. Minimum spaci
176621-2202Diagn.Port4-& 8-pos. DIP SwitchPHY Memory Power Isolation Isolation Isolation Screw Connector Screw Connector SHDSL modem DSLInterfaceR
26621-2202Legal informationThe contents of this document are provided “as is”. Except as required by applicable law, no warranties of any kind, either
REV.F 6621-2202 2010-04 Westermo Teleindustri AB, SwedenWestermo Teleindustri AB • SE-640 40 Stora Sundby, SwedenPhone +46 16 42 80 00 Fax +46 16 42
36621-2202SafetyBefore using this unit:Read this manual completely and gather all information on the unit. Make sure that you understand it fully. Che
46621-2202Agency approvals and standards complianceFCC Part 15.105 Notice: This equipment has been tested and found to comply with the limits for a C
56621-2202Declaration of Conformity Westermo Teleindustri AB Declaration of conformity Org.nr/Postadress/Postal address Tel. Telefax Postgiro Ba
66621-2202Type tests and environmental conditionsElectromagnetic CompatibilityPhenomena Test Description Test levelsESD EN 61000-4-2 Enclosure contact
76621-2202DescriptionFunctional descriptionSHDSL represents the best of several symmetric DSL technologies that have been com-bined into a single indu
86621-2202Getting startedThe DDW-100 is easy to use and install, the units work in pairs, one as has to be config-ured as CO (Central Office) and one
96621-2202Diagnostic information:The DDW-100 can display diagnostic information using a terminal. program 1) Connect a Westermo standard cable 1211-2
Comments to this Manuals