Westermo DR-250 User's Guide download pdf (Page 15)

6622-2211

Getting started

IP Address

The default IP address of the DR-250 when delivered is 192.168.0.99.

IP address configuration

The IP address is configurable by the Web tool and/or by using a terminal program.

Below is an description of how to configure the IP address by using a terminal program.

1. If the address is known, connect to the unit from a Web browser with the address of

the DR-250. If the address is unknown, connect the serial RS-232 interface to a termi-

nal program with settings:

Data rate: 115.2 bit/s

Data bits: 8

Stop bits: 1

Parity: None

Flow control: None

2. Use any terminal-program to setup the IP-address, gateway and subnetmask.

Eth 0 ipaddr xxx.xxx.xxx.xxx (set up IP-address)

Eth 0 gateway yyy.yyy.yyy.yyy (set up Gateway)

Eth 0 mask zzz.zzz.zzz.zzz (set up subnetmask)

Eth 0 status (check settings)

Config 0 save (save configuration)

3. The unit is now ready for a complete configuration by the Web tool. Address DR-250

in a browser with the configured IP address. Note that the used computer have to be

on the same network as DR-250.

Username and Password for configuration

The DR-250 is username and password protected. These are used when connecting with

Web browser during configuration and with Telnet for diagnostics.

Default username: username

Default password: password

Restore Factory default settings

Note! This will clear your customized settings.

The factory default settings can be restored using the reset switch on the bottom of the

unit. Pressing (~15 sec) the switch gently with the tip of a pen or other suitable imple-

ment will generate a hardware reset.

Note! If the default address of the unit is valid on the connected network it is possible

to access the unit directly from a browser.

It is important to allow the DR-250 to complete the restore procedure. DO NOT press

the reset button again or power cycle the unit for at least 2 minutes.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Westermo DR-250 User's Guide Page 15